After a period of use, the laser equipment needs to be debugged and maintained to ensure normal operation. How can the laser cutting machine be debugged faster and better?

There are many components of the laser equipment, and the maintenance period of some parts is relatively short. It needs to be maintained frequently to have a good operating state, such as cutting speed and effect.

First, adjust the parameters of the laser cutting machine to improve the cutting speed of the machine.

Machine parameter setting is one of the main reasons that affect the cutting speed of the machine. In general, if the parameters are not adjusted well, its cutting speed is not good. Parameters are like actions related to a series of actions such as driving, starting and accelerating. If the parameters are not set properly, it will shake when starting, just like when you shift to a second gear to start the car. When adjusting this parameter, generally pay attention to the following points:

1. Initial speed

As the name implies, this setting is the starting speed of the machine, just like the starting speed of the car in the process of driving. Many customers have such a misconception that the larger the initial speed, the better, but this is actually wrong. If the initial speed of the laser cutting machine is set too high, the machine jitter will be very large.

2. Acceleration

Acceleration means the speed of the fuel door during driving. It is the time from the initial speed to the normal cutting of the machine. When cutting different patterns, the laser cutting machine is a process of continuous start and stop. If the acceleration is set too low, the cutting speed of the machine will be slow.

Second, adjust the machine assembly to improve the cutting effect.

1. Guide rail installation

The guide rails should be installed in parallel. If the installation is not parallel, there will be resistance when the laser cutting machine runs. When it walks, it will be stuck, and when it cuts, there will be serrations. Therefore, the two guide rails in the Y direction can only be installed with two parallel lines, and there can be no error between them.

2. The installation position of beam and coupling is not good

When the machine beam and coupling are installed, the screws are not locked, or when they are locked, they are inclined, and so on.