How to improve the accuracy of laser engraving machine

1. Manual adjustment. Adjust the plan of the laser engraving machine according to the manual operation. After adjusting the plan, check whether it is consistent with the parallel line. After confirming that the adjustment is correct, operate the laser engraving machine and rotate the spindle bearing of the machine tool. According to the manual adjustment, we can't find a suitable position to stop to ensure the accuracy of the laser engraving machine. We can make accurate measurements in the right place. Of course, if the raw materials of the manually carved kitchen countertops of the laser engraving machine are different, the accurate measurement results will also be different, so this factor must be considered in the case of manual adjustment.

2. Computer adjustment. Adjusting the accuracy of the laser engraving machine according to the computer is much more accurate than manual adjustment, but the share of difficulty has increased a lot. We can configure the control panel according to the actual operation of the laser engraving machine. For the laser engraving machine, the laser engraving machine is calibrated according to the inspection method. After calibration, the method can be stored in the operating procedure immediately.

How to deal with motor rust

1. Handmade. According to human resources, knocking, shoveling, scraping, grinding or flexible filing can effectively remove surface rust, oxide skin, etc. These methods are used by some painters to remove rust, and rust prevention treatment can also be carried out according to its relatively simple and easy use of gray knives, scrapers and other sharp objects, but using this method is easy to cause damage to mechanical equipment, and maintenance work can be carried out under the condition of rust prevention treatment. The operator must also be very careful. If you are not careful, it is likely that the main shaft bearing of the laser engraving machine will be misaligned with the projection guide rail.

2. Use detergent. A convenient and quick way is to remove it with detergent. Spray the motor evenly according to the use of the spray bottle. After the detergent is completely covered, it can be wiped clean with cotton cloth after more than half an hour. If there is some rust that cannot be cleaned, you can spray it several times with a spray bottle, which will lead to the main shaft bearing of the laser engraving machine not rusting, and the lubricating cleaner is not conductive, which has a good expected effect of lubrication.