Air compressor is used to compress gas. Therefore, it is a device used to convert the mechanical energy of the prime mover (usually the motor) into pneumatic energy. And a pressure generator for compressed air. Therefore, the air compressor is an indispensable part of the optical fiber laser cutting machine system. Therefore, the following is the maintenance of its main components.

How to maintain the air compressor of laser cutting machine?

1. Air filter. Generally speaking, clean the dust and impurities on the air filter surface every 500 hours, and check whether it needs to be replaced every 2000 hours. The inspection or replacement cycle can determine the dust content by referring to the instructions.

2. Air inlet valve seal. To check the condition of the sealing ring in the air compressor of the laser cutting machine every 4000 hours of operation, replace it if necessary.

3. Compressor lubricating oil. Change the lubricating oil every 4000 hours.

4. Engine oil filter. Change every 2000 hours.

5. Oil vapor separator. Therefore, it needs to be changed every 4000 hours.

6. Pressure valve. Clean every 4000 hours and check whether the opening pressure is normal.

7. Safety valve. Check the sensitivity every 4000 hours.

8. Fuel outlet valve. Therefore, drain water and dirt every 2000 hours.

9. Drive belt. Therefore, adjust the air tightness every 2000 hours, check the wear condition every 4000 hours, and then decide whether to replace according to the wear condition.

10. Motor maintenance. Therefore, please follow the motor instructions for maintenance.

In order to ensure the normal operation of the air compressor of the laser cutting machine, we remind you to formulate a detailed maintenance plan, and then carry out special operations, regular maintenance, inspection and regular maintenance to keep the air compressor unit clean and free of oil and dirt.