The price of laser cutting machine is not low, thousands. Therefore, extending the service life of the laser cutting machine as far as possible can better save production costs, which shows that the daily maintenance of the laser cutting machine is very important. How to reduce the loss of laser cutting machine.

First, when the cutting machine is required to work, we need to push the beam before starting the machine, try to make it move forward and backward, move left and right without any abnormal noise, and then turn on the power. After completing the day's work, clean up the materials and waste generated in the machine. In this way, the mobile system of the machine can be protected from damage caused by foreign material operation. Clean its moving parts to keep the machine in good working condition. The specific methods are as follows:

1. Add a little lubricating oil to the screws, including the screws on the laser tube bracket and the first reflector, to facilitate disassembly and assembly during maintenance. Note: Do not add lubricating oil to timing belt, drag chain, air pipe, motor, sensor, lens and wire.

2. Do not place objects in the machine to avoid unnecessary damage to the machine.

3. Clean the dust and foreign matters on the metal oil tanker, metal shaft, sliding block and linear guide rail with cotton cloth, refill the lubricating oil, and conduct empty reciprocating movement.

How to reduce the loss of laser cutting machine?

Routine maintenance of laser cutting machine:

1. Replace the circulating water and clean the water tank: Before the machine works, make sure that the laser tube is full of circulating water. The quality and temperature of circulating water directly affect the service life of laser tubes. Therefore, the circulating water must be replaced regularly and the water tank must be cleaned regularly. It is best to do this once a week.

2. Fan cleaning: long-term use of the fan in the machine will cause the fan to accumulate a large amount of solid dust, make the fan produce a lot of noise, and is not conducive to exhaust and deodorization. When the suction of the fan is insufficient and the exhaust is not smooth, the fan should be cleaned.

3. Lens cleaning: there will be some mirrors and focus mirrors on the machine. The laser is reflected and focused through these lenses, and then emitted from the laser hair. The lens is easy to be stained with dust or other pollutants, which may cause laser loss or lens damage. Therefore, clean the lenses every day.

be careful:

1. Wipe the lens gently to avoid damaging the surface coating;

2. Handle with care during wiping to prevent falling;

3. When installing the focusing lens, make sure that the concave side is downward.

What are the ways to reduce the loss of laser cutting machine? Although laser cutting machine is widely used, its main direction is metal cutting, and can cut quickly. Therefore, the cutting pattern is very accurate. It not only improves the artistic taste and technical content of sheet metal processing, but also expands the profit space. Therefore, operators must carry out some training before operation and use them carefully, so that the equipment can better serve everyone.