Preparation before equipment installation

In order to successfully complete the installation and commissioning of the optical fiber laser cutting equipment, the manufacturer's technicians need to communicate with the customer in advance. The preparatory work includes:

The customer is required to contact the forklift of the corresponding tonnage of the equipment in advance to prepare for the unloading of the machine. The customer needs to arrange personnel to follow up and participate in training, including machine arrival inspection, machine installation, machine operation debugging, machine maintenance and precautions.

Customers need to prepare oxygen, nitrogen or clean oil-free air and other air sources (the higher the gas purity, the better the cutting quality) to facilitate machine debugging and use.

The stainless steel or carbon steel plate prepared or planned to be processed by the customer is easy for machine debugging and cutting.

Customers need to book the installation location of the machine in advance to facilitate the installation of the machine.

In order to facilitate the installation and use of the machine, customers need to prepare 2 barrels or about 40 liters of pure water, plasma water or distilled water.

The machine must be effectively grounded. The customer shall book the grounding equipment or place in advance to facilitate the installation of grounding wire.

The customer needs to prepare the electronic layout of relevant cutting drawings in advance to facilitate the use of debugging tables.

The customer needs to prepare the power supply and decide the type of circuit breaker according to the power of the equipment.

Organization and training of personnel. The optical fiber laser cutting machine is expensive. During the initial installation and commissioning, it shall be installed and commissioned in cooperation with the relevant technical engineers. The units that need to install equipment shall make thorough preparations before the arrival of the engineers, so as not to affect the installation and commissioning progress. The work includes:

Operators of optical fiber laser cutting machine shall be carefully selected. In the selection process, NC operators shall be selected according to the operating skills of the personnel, and shall have good NC knowledge, flexible and agile reaction ability and sense of responsibility.

The main responsibility of the equipment monitoring personnel is to formulate and implement plans and measures to prevent damage caused by the laser beam; Setting and management of laser control area, control of equipment operation keys; Equipment inspection, maintenance and service.

Carry out safety education for equipment. Basic knowledge of laser, dangerous voltage and other related knowledge, and complete machine operation training. The appointment of equipment operators should also be carefully considered. The equipment operator shall be appointed by the laser equipment monitoring personnel, who has the basic knowledge of hazard handling, laser and dangerous voltage and other related basic knowledge, and has received comprehensive training in machine tool operation.

Installation, commissioning and maintenance of laser cutting machine

Installation process of optical fiber laser cutting machine

When installing optical fiber laser cutting equipment, mechanical equipment such as cranes or forklifts should be used appropriately. At the same time, the personnel who install the optical fiber laser cutting equipment should also carefully plan and prepare for installation and commissioning.

Main procedures for installing optical fiber laser cutting equipment:

Arrange customer service personnel in advance to coordinate the embedding of machine foundation according to the actual situation, communicate with customers, and carry out foundation construction according to the foundation drawings.

After arriving at the equipment, carefully check whether the appearance of the equipment is deformed, and check the equipment parts.

After receiving the equipment, place and install the mat or floor. Most installations of pads require welding.

Lift the equipment or use a forklift to adjust the equipment and position it accurately.

Install the feet and fix them by secondary welding after leveling. After completing the above steps, you can start debugging.