The characteristics of the 4060 laser engraving and cutting machine are as follows


Good effect: fast cutting speed, firm and no grinding, high precision.


1 High efficiency: the equipment is ready to use, easy to operate, and the cutting and engraving speed is 8 to 10 times that of traditional crafts.


2 Low cost: no consumables, no surface treatment, no need to hire professionals with high salaries. General workers can learn immediately, the operating environment is more comfortable, and it is easy to weld complex fonts.


3 High stability: The laser is imported from the UK, with a lifespan of 8 to 10 years, stable performance, high power, and the number of times the xenon lamp emits light is more than 8 million times. Can operate continuously for 24 hours.


In the laser engraving machine, in addition to the laser tube as a consumable, we often pay attention to the burden of our maintenance on the lens and the vibrating mirror.


1. Check the focusing mirror and reflector. After working for a while, the frame will heat up, the surface of the lens will change color and rust; the film will be cracked and cracked are all objects to be replaced, especially many customers use air pumps and air compressors. Water will quickly accumulate on the lens, so it is necessary to check the cleanliness and quality of the lens optical system on time.


3. The power of the power grid should match.


4. The working environment of the laser cutting machine should not be too harsh. If the ambient temperature is higher than 30 degrees and lower than 18 degrees, there will be too much dust and serious air pollution, so that the machine will be seriously damaged and the failure rate will continue to rise; electrical accessories in humid environments It's easy to go wrong.


How to adjust the coordination of current and speed to get the best engraving effect?


1. The water protection should be checked and cleaned frequently. The cooling water often cannot flush the water protection float switch or the water protection float switch does not reset, and the short circuit method cannot be used to solve the urgent need.


2. The suction device should be checked and cleaned regularly, and the air duct of the fan should be cleaned. Otherwise, a lot of smoke and dust will not be discharged, which will seriously and quickly pollute the lens and laser tube, and make the mechanical and electronic components easy to oxidize and cause poor contact.


3. The cooling system should be grounded, and the water tank and waterway should be cleaned frequently. The temperature control point of the cooling temperature control water tank should be reasonable, otherwise the laser tube will be easily damaged and the dew condensation power will be reduced, the cold water head of the tube will fall off, the service life will be greatly shortened, and sometimes it will not work, causing Change tubes constantly.