How to maintain and maintain laser cutting machines at high temperatures in summer

In summer, as temperatures rise around the country, many laser equipment can generate heat during use, resulting in some failures. Therefore, in order to avoid malfunctions in the use of laser cutting machines in summer, everyone must pay attention to the maintenance and repair of laser cutting machines, which can extend the service life of the machine.

In the hot summer, the large picture laser provides a warm reminder that whether it's for outings or outdoor work, heatstroke prevention measures should be taken well. We not only need to prepare for heatstroke prevention and cooling, but also need to maintain the laser cutting machine to prevent it from "heatstroke"

water-cooling

In high temperature weather, the deterioration rate of cooling water will also accelerate. It is recommended that users of laser cutting machines use regular distilled water or pure water, and regularly clean the scale to avoid causing the scale to adhere to the laser and the pipe, affecting the laser power; Note that the temperature of the cooling water should not differ significantly from the air temperature. As the summer temperature becomes higher and higher, the working pressure of the cooling system of the laser cutting machine increases sharply. It is recommended to check and maintain the internal pressure of the cooling machine before the onset of high temperatures, and adjust it to adapt to high temperature weather in a timely manner.

lubrication

Each guide rail should be regularly cleaned to remove dust and other debris to ensure the normal operation of the laser equipment. The rack should be regularly wiped and lubricated. The timing should be adjusted to shorten the time by 0.5-1 times compared to the spring and autumn seasons, and the oil quality should be kept under observation. For machinery operating in high temperature areas, appropriately increase the viscosity grade of the oil, and properly add oil if the temperature of the lipid oil is prone to change, ensuring lubrication without debris. Carefully check the straightness of the cutting table and rail of the laser cutting machine and the perpendicularity of the machine, and timely maintain and debug any abnormalities found. The guide rail should be regularly cleaned and lubricated, and the motor should also be regularly cleaned and lubricated to keep the machine in optimal condition at all times. The machine can move better during operation, cut more accurately, and the quality of the cut product will be higher.

line

Check and replace aging wires, plugs, rubber hoses, and connectors; Check whether the connector pins and wire ends of various electrical components are loose, and tighten them in a timely manner to avoid burning out of electrical appliances and unstable signal transmission caused by poor contact.

reminder

Note: Beware of frost formation on the laser machine. Due to the large difference between the temperature of the water cooler and the ambient temperature, frost formation can occur on the laser and cutting head, which can lead to damage to the equipment and lenses. Customers are requested to adjust the temperature of the water cooler. If it is not possible to adjust it, please contact the after-sales service in a timely manner to ask how to adjust it.

"Grinding knives does not delay firewood cutting, and even the most powerful machines need maintenance. Therefore, when the hot summer comes, protecting your" beloved machine "and always in the best state can bring greater benefits to yourself.".