Optical fiber laser cutting machine itself is a kind of machine and equipment with high efficiency. Especially now, it can operate automatically with CNC machine tools. However, some customers report that they have low efficiency when using this kind of equipment. Therefore, we should find out the specific reasons at this time, so that we can find out the problems and solve them, so as to improve the production efficiency. Let's take a look at some common factors that can affect the operating efficiency of this machine.
In the process of using the optical fiber laser cutting machine, the efficiency may be reduced due to the power problem. For example, some customers may purchase a small power machine and equipment. The power is relatively small but the thickness of the cutting parts or materials is relatively large, which will lead to a decline in the cutting efficiency. In this case, there are two solutions. The first is to replace a high-power equipment, The second way is to find ways to reduce the thickness of the material being cut. In addition, there is another reason that affects the efficiency. This kind of machine needs to be used in conjunction with the computer system. The computer system used by some customers may have some unstable factors. In this case, the efficiency may decline. For example, there may be some problems with the computer CPU or the computer hard disk, which may lead to performance degradation, If the cutting accuracy or the cutting quality decreases, you need to conduct an overall inspection of the computer system. If there is a problem with the hard disk, such as a decrease in the read/write speed of the hard disk, you may need to replace the hard disk at this time, or it may be due to insufficient CPU performance, so you need to replace a CPU with strong performance. The third reason that affects the efficiency is that the drawing parameters are set incorrectly, or the design of the drawing itself is defective. At this time, you can only modify the drawing again, and then restart the machine for tentative cutting.
Pay special attention to nine aspects of using the optical fiber cutting machine. This machine is a highly efficient machine. Under the control of the computer, the machine can be operated fully automatically, and the cutting accuracy is very high. It is a kind of machine and equipment that is very fast and really welcomed by users. Although the machine itself is a good machine, there are still some details in the use process, which must be noted, otherwise it may lead to safety accidents when using, or it is easy to cause the accuracy of the cut products to fail to meet the requirements. Now let's briefly introduce these nine noteworthy problems.
The first thing to pay attention to in the process of using the optical fiber cutting machine is that all novices need to have some skill training before operating the machine. After training, they can know the structure and performance of the machine, and then they can know the precautions for using the machine. After training, they must be assessed, and only after passing the assessment can they operate the machine. The second problem to be noted is that the rules and regulations for operating this machine should be established, and the operation and maintenance should be carried out in strict accordance with the rules and regulations. The third thing to pay attention to is to take protective measures before operating the machine, especially wear goggles. The fourth thing to note is that this machine must be placed in a dry and clean environment for construction. In some operating environments, flammable and explosive materials cannot be placed. Fire extinguishers should be added in the environment where the machine is placed. The fifth thing to note is that the machine may fail during operation. The correct way to do this is to immediately shut down the machine, and then report to the technical department or look for after-sales solutions. The sixth thing to note is that operators cannot leave their posts when the machine is running. If they want to leave, they can choose to shut down the machine or entrust others to take care of it. The seventh thing to note is that a trial run should be carried out every day before starting the machine for operation. Only when everything is in good condition can the machine be started again.
The eighth problem to be noticed when using the optical fiber cutting machine is that if it is to process large quantities of workpieces, it is necessary to perform trial processing first, and record the problems in the operation process. If all the trial processing is normal, batch processing can also be performed. If it is abnormal, the reason should be found out. After the problem is solved, it is necessary to perform trial operation again, and the next step can be continued only after the operation is qualified. The ninth thing to pay attention to is that regular maintenance must be carried out, and the wear of various parts must be checked regularly.
Leave a Comment