The laser cutting machine must be operated under strict safety awareness, otherwise it will lead to safety accidents:

1. Follow the general safety operation procedures for the cutting machine, and start the laser, adjust the light, and test the machine in strict accordance with the laser startup procedure.

⒉. The operator must be trained to be familiar with the cutting software, equipment structure and performance, and master the knowledge related to the operating system.

3. Wear labor protection articles as required, and wear protective glasses that meet the requirements near the laser beam.

4. Do not process a material before knowing whether it can be irradiated or cut by laser, so as to avoid the potential danger of smoke and steam.

5. When the equipment is started, the operator shall not leave the post or entrust others to be in charge without authorization. If it is really necessary to leave, the machine shall be shut down or the power switch shall be cut off.

6. Keep the fire extinguisher within easy reach. Turn off the laser or the shutter when not processing. Do not place paper, cloth or other combustibles near the unprotected laser beam.

7. In case of any abnormality during processing, stop the machine immediately to eliminate the fault or report to the supervisor.

8. Keep the laser, laser head, bed and surrounding site clean, orderly and free of oil stain, and stack workpieces, plates and waste materials as required.

9. When using gas cylinders, avoid crushing welding wires to avoid electric leakage accidents. The use and transportation of gas cylinders shall comply with the gas cylinder supervision regulations. Gas cylinders shall not be exposed to the sun or close to heat sources. When opening the bottle valve, the operator must stand at the side of the bottle mouth.

10. High voltage safety regulations shall be observed during maintenance. Maintenance shall be carried out every 1 day or every week, every 1000 hours or every six months according to regulations and procedures.

11. After starting the machine, start the machine tool manually in the direction of X, Y and B axes at low speed, and check whether there is any abnormality.

12. After entering the new workpiece program, it is necessary to test run it first and check its operation.

13. During operation, observe the operation of the machine tool to avoid accidents caused by the cutting machine going out of the effective travel range or collision between two machines.

14. If the equipment is in automatic operation, there is a certain danger, and it is not allowed to enter the safety fence. Safety must be paid attention to during any operation. Entering the operating range of the machine at any time may cause serious injury.

15. When feeding, be sure to watch the feeding state to prevent the plate from arching and hitting the laser head, causing serious consequences. 16. Before production and operation, check whether all preparations are in place, whether the protective gas is turned on, whether the air pressure is reached, whether the laser is on standby, and whether the feeding robot is in automatic state.