It is inevitable that the laser cutting machine will have some small problems when it is working. For example, the laser cutting machine will have serrations when cutting and processing materials. Here is the big picture of the laser to explain the reasons for the serrations

1： If the laser cutting machine vibrates, the products it cuts will have serrations. First, it is the external situation of the machine. For example, whether the water tank and the exhaust fan are too close to the laser cutting machine. If they are close to the machine tool, they will vibrate the machine tool when they are running. When the machine is cutting materials, they will vibrate, affecting the edge effect of cutting.

2： The parallelism of the machine is not properly installed, so the machine will be unstable when running, and shake will occur during its operation, and sawtooth will also occur on the cut products.

3： The lens is not locked. If the lens is not locked, the lens will also vibrate when the device is running, and the light will also vibrate when cutting. The processed product will not have good effect, and there will also be sawtooth.

4： There is wear in the slider, and it shakes when running on the guide rail. Therefore, when cutting materials, sawtooth will also occur.

5： The two guide rails in the Y direction are not installed in parallel. They will get stuck when running, and there will be sawtooth when cutting.