The water chiller of the fiber laser cutting machine must be properly arranged to play its normal role. Don't underestimate this inconspicuous move. If the water chiller cannot play its full role, it will greatly affect the production efficiency of the fiber laser cutting machine. Now let's talk about the installation location and location requirements of the water chiller of the fiber laser cutting machine:

1. The water chiller of optical fiber laser cutting machine is suitable for indoor installation, with ambient temperature of 5 ℃ to 35 ℃ and relative humidity of no more than 80% (no condensation);

2. The chiller shall be installed on a stable horizontal surface, as close as possible to the cooled body, and at least 1.4 meters away from the heat source;

3. In order to prevent voltage drop, the water chiller should be as close as possible to the power board. We do not recommend using the power extension cord to ensure that the power outlet and ground wire are correctly connected, and ensure that the voltage and frequency match the label on the rear of the water chiller;

4. The rated heat discharged by the cooling fan of the optical fiber laser cutting machine water chiller is about 1.4 times of the rated cooling capacity, so the water chiller can not lean against the wall on all sides, and a space of more than 0.8 meters should be reserved on the hot air discharge side, and the room should be fully ventilated.