The laser cutting machine equipment may have abnormal reset during use, so how to deal with it? First of all, we need to check which position is causing the problem. Let's look at several aspects that may cause abnormal reset:

1. Check the sensor for dust, poor contact or damage (wipe the dust on the sensor or replace it);

2. Check whether the flexible guide belt data cable is in poor contact or damaged (trim the data cable and plug it again or replace the data cable);

3. Check whether the ground wire contact is reliable or whether the high voltage wire is damaged (grounding again or replacing the high voltage wire);

4. The motor wire of the laser cutting machine has poor contact.

Here is how to deal with it:

The laser cutting machine missed engraving, initialization is incorrect, data has been sent, the operation sequence is reversed, electrostatic interference, cleaning and hooking dislocation, unclosed, check whether the software parameter setting is correct,; The computer system is wrong. Check whether the left and right belts are the same or whether the rear belt is too loose. Check whether the belt or synchronous wheel slips or jumps teeth, and check whether the crossbeam is parallel.